How To Light A Pilot Light On A Honeywell Furnace

January 16, 2022 By asta 1 0
How To Light A Pilot Light On A Honeywell Furnace

How To Light A Pilot Light On A Honeywell Furnace. The pilot light is a small burner that lights the larger furnace burners, and you can usually find it at the bottom of the furnace. Turn the gas valve counterclockwise until it reads 'pilot.' push the red 'reset' button and hold it down while you light the pilot burner with a match.

How To Light A Pilot Light On A Honeywell FurnaceHow To Light A Pilot Light On A Honeywell Furnace
Difficulty Lighting Honeywell Gas Pilot Light Ducted from www.doityourself.com

Then, hold down the reset button and bring the flame of a. It’s possible that the gas pilot light went out originally because your furnace has an issue that needs to be repaired. Wait five minutes for any gas remaining in the furnace to vent.

If You Have No Igniter, Move The Match Or Barbecue Lighter Flame To The End Of The Pilot Tube;

Wait five minutes for any gas remaining in the furnace to vent. When a call for heat comes, the inducer motor (the one that blows the combustion gasses out the plastic pipe) starts, the vacuum produced closes a pressure switch and sends voltage to the honeywell ignition module which should start a sparking at the pilot and energize the gas valve. Wait five minutes for any gas remaining in the furnace to vent.

57 Reference Of Pilot Light Lennox Gas Furnace In 2020.

Turn the gas valve counterclockwise until it reads 'pilot.' push the red 'reset' button and hold it down while you light the pilot burner with a match. Gas furnace controls last modified by: Turn the gas valve counterclockwise until it reads 'pilot.' push the red 'reset' button and hold it down while you light the pilot burner with a match.

Set Your Thermostat To The Lowest Setting And Unplug Your Furnace.

That furnace has an automatic ignition system. The pilot light is a small burner that lights the larger furnace burners, and you can usually find it at the bottom of the furnace. Then, hold down the reset button and bring the flame of a.

The Reset Button Can Be Released Once The Flame Has Burned For About 30 Seconds.

Light main burners, prove main burner flame. This should light the furnace pilot light. As a way to light the furnace pilot light, use an unusually long lighter.

The Sequence Of Operation Would Be Either:1.

Once the button is pressed to reset the computer, put the switch to “pilot” and turn it on. This should light the furnace pilot light. 58sta/58stx furnaces have a rating of 80% afue.